Vega Medical Equipment(Shanghai)
Categories
Contact Us
Vega Medical Equipment(Shanghai)
Add: No.618, Jianyun Road, Zhoupu Industrial Park, Pudong New Area, Shanghai, China
Tel: +86-021-67105200
Mobile: +86-15900473404
E-mail: sales@vega-medical.com.cn
Knowledge
Home > Knowledge > Content
Standard for production and detection of electric hospital bed
Feb 26, 2018

In recent years, the rapid development of the medical industry, improvement of medical conditions is great to protect people's health, and medical equipment is also booming, one of the electric beds is also a large number of medical devices, as medical devices allow the patient to rest and recuperation, its status is very important function to bring comfort and convenience, scientific design the little effect on the rehabilitation of patients to. It is a common medical device in the hospital, but few people know its production and testing standards.


One:Standard for the production of electric sickbeds:

1. the purchase of raw materials. The other party must be required to have complete relevant documents. For ABS and other materials, it is not recommended to use reprocessed ABS materials. And the manufacturer's raw material purchase must be checked up.

2. the size of the electric sickbed. As the electric medical bed manufacturers, their grasp of the size of the electric beds mainly follow the population out of the investigation data, the state released every few years, what is the average weight per capita, how much is the height of electric medical bed manufacturers will according to the relevant data of the medical beds were more length and width adjustment. In addition, the sickbeds produced by this company are high, and all parts can be adjusted and expanded to meet the needs of the vast majority of patients.

3. related process problems of electric sickbed production. According to the relevant provisions, the electric bed steel pipe must be strictly removed rust process, because if this process is not strict, it will seriously reduce the service life of the electric bed.

4. the spraying work of the electric bed: according to the relevant regulations, the electric bed must be sprayed for three times, so that the spray surface can be firmly attached to the surface of the electric medical bed, and it will not fall off in a short time. Most of the metal parts, such as surgical lamp, bed and operating bed, are mostly electrostatic spraying and plating, and the appearance is bright and clean.


Two:The standard of electric sickbed detection:

For the manufacturers, the content of the electric sickbed inspection standard is very important, because the relevant departments of the state have set out very strict inspection standards. So as an electric sickbed industry, first of all, we should know what important testing standards for electric sickbeds in the country. And strictly according to the national standards. One more important thing is the technical requirements. Many small manufacturer's products are not tested mainly because their production technology is unable to meet the requirements of testing.

The next is the testing of the material of the electric medical bed. Both the stainless steel material, or the ABS full plastic, should meet the requirements of the national standard on the thickness and the soft and hard. For example, steel plates and steel tubes with a thickness of 12mm are to be used as steel. If the material thickness can not meet this standard, it is difficult to guarantee the quality requirements after finished products. Especially after putting into use, there will be many problems, which will cause many after-sale problems and customer experience.


  • Newsletter
  • Categories
  • Contact Us
    Vega Medical Equipment(Shanghai)
    Add: No.618, Jianyun Road, Zhoupu Industrial Park, Pudong New Area, Shanghai, China
    Tel: +86-021-67105200
    Mobile: +86-15900473404
    E-mail: sales@vega-medical.com.cn
  • QR Code
  • Copyright © Vega Medical Equipment (Shanghai) All Rights Reserved.